User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Show Commands
264
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Port Triggering Show Commands
show security porttriggering_rules setup
This command displays the port triggering rules:
Port Triggering
_______________
List of Available Port Triggering Rules
_______________________________________
ROW ID: 1
Name: AccInq
Enable: Yes
Type: TCP
Interface: LAN
Outgoing Start Port: 20020
Outgoing End Port: 20022
Incoming Start Port: 30030
Incoming End Port: 30040
show security porttriggering_rules status
This command displays the port triggering status:
PortTriggering Rules Status
___________________________
UPnP Show Commands
show security upnp portmap
This command displays the UPnP portmap table:
UPnP Portmap Table
__________________