User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Show Commands
259
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Destination: Broadband
Bandwidth Profile: NONE
Log: Never
show security firewall ipv4 setup dmz_wan
This command displays the configured IPv4 DMZ WAN firewall rules:
Default Outbound Policy for IPv4 : Allow Always
DMZ WAN Outbound Rules.
_______________________
ROWID: 105
Status: Enabled
Service Name: FTP
Filter: ALLOW by schedule,otherwise block
DMZ User: Any
WAN User: Any
Priority: Maximize-Reliability
Log: Never
DMZ WAN Inbound Rules.
______________________
ROWID Status Service Name Filter DMZ Server IP Address DMZ User WAN User Destination Log
_____ _______ ____________ ____________ _____________________ ________ ________ _____________ ______
106 Enabled Traceroute ALLOW Always 176.21.214.2 Any 10.115.97.174 Always
107 Enabled TELNET ALLOW Always 176.21.214.2 Any Broadband Always
show security firewall ipv4 setup lan_dmz
This command displays the configured IPv4 LAN DMZ firewall rules:
Default Outbound Policy for IPv4 : Allow Always
LAN DMZ Outbound Rules.
_______________________
ROWID: 100
Status: Enabled
Service Name: FTP
Filter: ALLOW Always
LAN User: GROUP3