User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Show Commands
257
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Mcast: 0
Coll: 0
FVS318N> show net statistics all
Interface Statistics
____________________
IFACE PktRx PktTx ByteRx ByteTx ErrRx ErrTx DropRx DropTx Mcast Coll
_____ ______ ______ ________ ________ _____ _____ ______ ______ _____ ____
eth0 20802 31569 2148358 38409384 0 0 0 0 0 0
eth1 359059 186965 61156441 28586367 0 0 0 0 0 0
Security Settings (Security Mode) Show Commands
This section contains the following subsections:
• Services Show Command
• Schedules Show Command
• Firewall Rules Show Command
• Attack Checks Show Commands
• Session Limits Show Commands
• Advanced Firewall Show Commands
• Address Filter Show Commands
• Port Triggering Show Commands
• UPnP Show Commands
• Bandwidth Profiles Show Command
• Content Filtering Show Commands
Services Show Command
show security services setup
This command displays the configured custom services:
List of Available Custom Services
_________________________________
ROW ID Name Type ICMP Type / Port Range QoS
______ ________________ ______ ______________________ ___________________
74 Ixia TCP 10115-10117 Normal-Service
75 RemoteManagement TCP 8888-8888 Maximize-Throughput