User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Show Commands
251
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
show net ethernet {interface name | all}
This command displays the MAC address and VLAN status for a single or all Ethernet
interfaces:
FVS318N> show net ethernet eth1
MAC Address: AA:AB:BB:00:00:02
VLAN ID: 1
Interface Name: eth1
VLAN Enabled: N
Native VLAN: N
FVS318N> show net ethernet all
Ethernet Interfaces
___________________
VLAN ID Interface Name VLAN Enabled Native VLAN
_______ ______________ ____________ ___________
1 eth0 N N
1 eth1 N N
show net lan ipv4 advanced setup
This command displays the advanced IPv4 LAN configuration:
LAN Advanced Setup
__________________
VLAN MAC Settings:
MAC Address for VLANs: Same
Advanced Settings:
ARP Broadcast: Enabled
show net lan available_lan_hosts list
This command displays the IPv4 hosts (that is, the known computers and devices in the
LAN):
List of Available Lan Hosts
___________________________