User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
245
9
9. Show Commands
This chapter explains the show commands and associated parameters for the five configuration
command modes. The chapter includes the following sections:
• Network Settings (Net Mode) Show Commands
• Security Settings (Security Mode) Show Commands
• Administrative and Monitoring Settings (System Mode) Show Commands
• Wireless Settings (Dot11 Mode) Show Commands
• VPN Settings (VPN Mode) Show Commands
Network Settings (Net Mode) Show Commands
This section contains the following subsections:
• WAN (IPv4 and IPv6) Show Commands
• IPv6 Mode and IPv6 Tunnel Show Commands
• LAN DHCP Show Commands
• Dynamic DNS Show Commands
• IPv4 LAN Show Commands
• IPv6 LAN Show Commands
• DMZ Show Commands
• Routing Show Commands
• Network Statistics Show Commands
WAN (IPv4 and IPv6) Show Commands
show net wan_settings wanmode
This command displays the IPv4 WAN routing mode:
Routing Mode between WAN and LAN
__________________________________
NAT is Enabled