User's Manual

Overview of the Show Commands
242
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Administrative and Monitoring Settings (System Mode)
Show Commands
Enter the show system ? command at the CLI prompt to display the categories of show
commands in the system mode. The following table lists the commands in alphabetical order:
firewall
(continued)
show security firewall session_limit Display the session limit settings.
show security firewall session_settings Display the session time-out settings.
porttriggering_rules
show security porttriggering_rules setup Display the port triggering rules.
show security porttriggering_rules status Display the port triggering status.
schedules show security schedules setup Display the configured schedules.
services show security services setup Display the configured custom services.
upnp
show security upnp portmap Display the UPnP portmap table.
show security upnp setup Display the UPnP configuration.
Table 16. Show commands: show system mode
Submode Command Name Purpose
not applicable
show sysinfo Display system information, including MAC
addresses, serial number, and firmware
version.
show system firmware_version Display the firmware version.
logging
show system logging setup Display the configuration of the IPv4 and
IPv6 logs.
show system logging remote setup Display the configuration and the schedule
of the email logs.
logs show system logs Display the system logs.
remote_management show system remote_management setup Display the configuration of remote
management for Telnet and HTTPS access.
snmp
show system snmp sys Display the SNMP system configuration of
the SNMP agent and the SNMP system
information of the wireless VPN firewall.
show system snmp trap [agent ipaddress] Display the SNMP trap configuration of the
SNMP agent.
status show system status Display the system status information.
Table 15. Show commands: show security mode (continued)
Submode Command Name Purpose