User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Overview of the Configuration Commands
24
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Administrative and Monitoring Settings (System Mode)
Configuration Commands
Enter the system ? command at the CLI prompt to display the description of all the
configuration commands in the system mode. The following table lists the commands in
alphabetical order:
schedules
security schedules edit <1 | 2 | 3> Configure one of the three
security schedules.
services
security services add Configure a new custom
service.
security services delete <row id> Delete a custom service.
security services edit <row id> Configure an existing custom
service.
upnp security upnp configure Configure UPnP.
Table 9. System mode configuration commands
Submode Command Name Purpose
logging
system logging configure Configure routing logs for accepted and
dropped IPv4 and IPv6 packets.
system logging remote configure Configure email logs and alerts,
schedule email logs and alerts, and
configure a syslog server.
remote_management
system remote_management https configure Configure remote management over
HTTPS.
system remote_management telnet configure Configure remote management over
Telnet.
snmp
system snmp sys configure Configure the SNMP system information.
system snmp trap configure <ip address> Configure an SNMP agent and
community.
system snmp trap delete <ipaddress> Delete an SNMP agent.
time system time configure Configure the system time, date, and
NTP servers.
traffic_meter system traffic_meter configure Configure the traffic meter.
Table 8. Security mode configuration commands (continued)
Submode Command Name Purpose