User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
239
8
8. Overview of the Show Commands
This chapter provides an overview of all show commands for the five configuration command
modes. The chapter includes the following sections:
• Network Settings (Net Mode) Show Commands
• Security Settings (Security Mode) Show Commands
• Administrative and Monitoring Settings (System Mode) Show Commands
• Wireless Settings (Dot11 Mode) Show Commands
• VPN Settings (VPN Mode) Show Commands
Network Settings (Net Mode) Show Commands
Enter the show net ? command at the CLI prompt to display the categories of show
commands in the net mode. The following table lists the commands in alphabetical order:
Table 14. Show commands: show net mode
Submode Command Name Purpose
ddns show net ddns setup Display the Dynamic DNS configuration.
dmz show net dmz ipv4 setup Display the IPv4 DMZ configuration.
show net dmz ipv6 setup Display the IPv6 DMZ configuration.
ethernet show net ethernet {interface name | all} Display the MAC address and VLAN status for a
single or all Ethernet interfaces.
ipv6 show net ipv6 ipmode setup Display the IPv6 routing mode configuration.
ipv6_tunnel
show net ipv6_tunnel setup Display the IPv6 tunnel configuration.
show net ipv6_tunnel status Display the status of the IPv6 tunnels.
lan
show net lan available_lan_hosts list Display the IPv4 hosts.
show net lan dhcp leased_clients list Display the LAN clients that received a leased
DHCP IP address.
show net lan dhcp logs Display the LAN DHCP log.