User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
VPN Mode Configuration Commands
235
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
ip_version IPv4 or IPv6 The IP version that applies to the policy:
• IPv4. The policy is for an IPv4 network
resource, IPv4 address, IPv4 network, or for
all IPv4 addresses.
For an IP address or IP network, you need to
issue the policy_address keyword and
specify an IPv4 address. For a network
address, you also need to issue the
policy_mask_length keyword and specify
a subnet mask.
• IPv6. The policy is for an IPv6 network
resource, IPv6 address, IPv6 network, or for
all IPv6 addresses.
For an IP address or IP network, you need to
issue the policy_address6 keyword and
specify an IPv6 address. For a network
address, you also need to issue the
policy_ipv6_prefix_length keyword
and specify a prefix length.
policy_address ipaddress The IPv4 address, if the policy is for an IPv4
address or IPv4 network.
policy_mask_length subnet mask The subnet mask, if the policy is for an IPv4
network.
policy_address6 ipv6-address The IPv6 address, if the policy is for an IPv6
address or IPv6 network.
policy_ipv6_prefix_length
prefix length The prefix length, if the policy is for an IPv6
network.
start_port port number The start port number for a policy port range.
(This does not apply if the policy is for a
network resource.)
end_port port number The end port number for a policy port range.
(This does not apply if the policy is for a
network resource.)
service_type VPNTunnel,
PortForwarding, or All
The service type for the policy:
• VPNTunnel. The policy is applied only to a
VPN tunnel.
• PortForwarding. The policy is applied only to
port forwarding.
• All. The policy is applied both to a VPN
tunnel and to port forwarding.
Keyword Associated Keyword to
Select or Parameter to Type
Description