User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
VPN Mode Configuration Commands
233
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
policy_owner group name or user name The owner of the policy depends on the setting
of the policy_type keyword:
• Group. Specify the group name to which the
policy applies.
• User. Specify the user name to which the
policy applies.
destination_object_type
NetworkResource,
IPAddress, IPNetwork, or
All
Note: You cannot change an existing
destination object type.
The policy destination type, which determines
how the policy is applied, and, in turn, which
keywords you need to issue to specify the
policy:
• NetworkResource. The policy is applied to
an existing IPv4 or IPv6 resource. For
information about how to create and
configure network resources, see SSL VPN
Resource Commands. You need to issue the
following keywords and their associated
parameters and keywords:
- policy_name
- ip_version
- resource_name
- policy_permission
- policy_owner if the policy_type
keyword is set to Group or User.
• IPAddress. The policy is applied to a single
IPv4 or IPv6 address. You need to issue the
following keywords and their associated
parameters and keywords:
- policy_name
- ip_version
- policy_address or
policy_address6 (depending on the
setting of the ip_version keyword)
- start_port and end_port
- service_type
- policy_permission
- policy_owner if the policy_type
keyword is set to Group or User.
Keyword Associated Keyword to
Select or Parameter to Type
Description