User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
VPN Mode Configuration Commands
229
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
destination_object_type
(continued)
NetworkResource,
IPAddress, IPNetwork, or
All
(continued)
• IPNetwork. The policy is applied to an IPv4
or IPv6 network address. You need to issue
the following keywords and their associated
parameters and keywords:
- policy_name
- ip_version
- policy_address and
policy_mask_length or
policy_address6 and
policy_ipv6_prefix_length
(depending on the setting of the
ip_version keyword)
- start_port and end_port
- service_type
- policy_permission
- policy_owner if the policy_type
keyword is set to Group or User.
• All. The policy is applied to all addresses.
You need to issue the following keywords and
their associated parameters and keywords:
- policy_name
- ip_version
- start_port and end_port
- service_type
- policy_permission
- policy_owner if the policy_type
keyword is set to Group or User.
resource_name resource name The name of a resource that you configured
with the vpn sslvpn resource add command.
This keyword and parameter apply only if the
policy is for a network resource.
policy_permission Permit or Deny Specifies whether the policy permits or denies
access.
Keyword Associated Keyword to
Select or Parameter to Type
Description