User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
VPN Mode Configuration Commands
226
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Step 2 Format policy_name <policy name>
policy type {Global | Group {policy_owner <group name>} |
User {policy_owner <user name>}}
destination_object_type {NetworkResource | IPAddress |
IPNetwork | All}
In addition to a policy name, policy type, and destination object type, configure the
following for a network resource:
ip_version {IPv4 | IPv6}
resource_name <resource name>
policy_permission {Permit | Deny}
In addition to a policy name, policy type, and destination object type, configure the
following for an IP address:
ip_version {IPv4 {policy_address <ipaddress>} | IPv6
{policy_address6 <ipv6-address>}}
start_port <port number>
end_port <port number>
service_type {VPNTunnel | PortForwarding | All}
policy_permission {Permit | Deny}
In addition to a policy name, policy type, and destination object type, configure the
following for an IP network:
ip_version {IPv4 {policy_address <ipaddress>}
{policy_mask_length <subnet mask>} | IPv6 {policy_add
ress6
<ipv6-address>} {policy_ipv6_prefix_length <prefix length>}}
start_port <port number>
end_port <port number>
service_type {VPNTunnel | PortForwarding | All}
policy_permission {Permit | Deny}
In addition to a policy name, policy type, and destination object type, configure the
following for all addresses (that is, the destination_object_type keyword is set to
All):
ip_version {IPv4 | IPv6}
start_port <port number>
end_port <port number>
service_type {VPNTunnel | PortForwarding | All}
policy_permission {Permit | Deny}
Mode [sslvpn-policy-settings]