User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
VPN Mode Configuration Commands
191
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
general_keep_alive_failue_count
number The maximum number of keep-alive request
failures before the wireless VPN firewall
tears down the connection and then attempts
to reconnect to the peer.
Traffic selector settings—Local address information
general_local_network_type
ANY, SINGLE,
RANGE, or SUBNET
Specifies the address or addresses that are
part of the VPN tunnel on the wireless VPN
firewall:
• ANY. All computers and devices on the
network.
• SINGLE. A single IP address on the
network. Depending on the setting of the
general_ip_version keyword, issue
one of the following keywords:
- general_local_start_address to
specify an IPv4 address.
-
general_local_start_address_ipv6
to specify an IPv6 address.
• RANGE. A range of IP addresses on the
network. Depending on the setting of the
general_ip_version keyword, issue
one of the following sets of keywords:
- general_local_start_address
and general_local_end_address
to specify IPv4 addresses.
-
general_local_start_address_ipv6
and
general_local_end_address_ipv6 to
specify IPv6 addresses.
• SUBNET. A subnet on the network.
Depending on the setting of the
general_ip_version keyword, issue
one of the following sets of keywords:
- general_local_start_address to
specify an IPv4 address and
general_local_subnet_mask to
specify a subnet mask.
-
general_local_start_address_ipv6
to specify an IPv6 address and
general_local_ipv6_prefix_length
to specify a prefix length.
general_local_start_address
ipaddress If the general_local_network_type keyword is
set to SINGLE, RANGE, or SUBNET, and if the
general_ip_version keyword is set to
IPv4, specifies the local IPv4 (start)
address.
Keyword (might consist of two separate
words)
Associated
Keyword to Select
or Parameter to
Type
Description