User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
VPN Mode Configuration Commands
190
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
general_remote_end_point
ipv6_adress
ipv6-address If the general_remote_end_point_type
keyword is set to IP-Address, and if the
general_ip_version keyword is set to
IPv6, the IPv6 address of the remote
endpoint.
general_enable_netbios
Y or N Enables or disables NetBIOS broadcasts to
travel over the VPN tunnel.
Note: If you enable NetBIOS, you do not
have to configure the remote address
information for the traffic selector settings
(that is, you do not need to issue any
keywords that start with general_remote).
auto_initiate_policy
Y or N Enables or disables the automatic
establishment of the VPN tunnel when there
is no traffic.
Note: You cannot enable automatic
establishment of the VPN tunnel if the
direction_type keyword under the vpn
ipsec ikepolicy configure <ike policy name>
command is set to Responder.
general_enable_keep_alive
Y or N Enables or disables the wireless VPN firewall
to send keep-alive requests (ping packets) to
the remote endpoint to keep the tunnel alive.
If you enable keep-alives, you also need to
issue the following keywords:
• Either general_ping_ipaddress to
specify an IPv4 address or
general_ping_ipaddress6 to specify
an IPv6 address.
•
general_keep_alive_detection_period
to specify the detection period.
• general_keep_alive_failue_count
to specify the failure count.
general_ping_ipaddress
ipaddress The IPv4 address to send keep-alive
requests to.
general_ping_ipaddress6
ipv6-address The IPv6 address to send keep-alive
requests to.
general_keep_alive_detection_period
seconds The period in seconds between consecutive
keep-alive requests, which are sent only
when the IPSec traffic is idle.
Keyword (might consist of two separate
words)
Associated
Keyword to Select
or Parameter to
Type
Description