User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
VPN Mode Configuration Commands
189
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
general_ip_version
IPv4 or IPv6 If the general_remote_end_point_type
keyword is set to IP-Address, specifies the
IP address version for the remote endpoint,
local address information, and remote
address information:
• IPv4. The IPv4 selection requires you to
specify IPv4 addresses for the following
keywords:
-
general_remote_end_point
ipaddress
- general_local_start_address
- general_local_end_address
- general_remote_start_address
- general_remote_end_address
• IPv6. The IPv6 selection requires you to
specify IPv6 addresses for the following
keywords:
- general_remote_end_point
ipv6address
- general_local_start_address_ipv6
- general_local_end_address_ipv6
- general_remote_start_address_ipv6
- general_remote_end_address_ipv6
general_remote_end_point_type
IP-Address or
FQDN
Specifies whether the remote endpoint is
defined by an IP address or a domain name:
• IP-Address. Depending on the setting of
the general_ip_version keyword, you
need to either issue the
general_remote_end_point
ip_address keyword and specify an IPv4
address or issue the
general_remote_end_point
ipv6_adress keyword and specify an
IPv6 address.
• FQDN. You need to issue the
general_remote_end_point fqdn
keyword and specify a domain name.
general_remote_end_point fqdn
domain name If the general_remote_end_point_type
keyword is set to FQDN, the domain name
(FQDN) of the remote endpoint.
general_remote_end_point ip_adress
ipaddress If the general_remote_end_point_type
keyword is set to IP-Address, and if the
general_ip_version keyword is set to
IPv4, the IPv4 address of the remote
endpoint.
Keyword (might consist of two separate
words)
Associated
Keyword to Select
or Parameter to
Type
Description