User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
VPN Mode Configuration Commands
188
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
manual_spi_out <number>
manual_authentication_algorithm {MD5 | SHA-1}
manual_authentication_key_in <key>
manual_authentication_key_out <key>
auto_sa_lifetime {bytes <number> | {seconds <seconds>}
auto_encryption_algorithm {None | DES | 3DES | AES-128 |
AES-192 | AES-256}
auto_authentication_algorithm {MD5 | SHA-1}
auto_enable_pfskeygroup {N | Y {auto_dh_group {Group1_768_bit |
Group2_1024_bit | Group5_1536_bit}}}
auto_select_ike_policy <ike policy name>
Mode vpn-config [vpn-policy]
Keyword (might consist of two separate
words)
Associated
Keyword to Select
or Parameter to
Type
Description
General policy settings
general_policy_type
Auto-Policy or
Manual-Policy
Species whether the policy type is an auto or
manual VPN policy:
• Auto-Policy. The inbound and outbound
policy settings for the VPN tunnel are
automatically generated after you have
issued the keywords and associated
parameters that are listed in the Auto policy
settings section of this table. All other VPN
policy settings need to be specified
manually.
• Manual-Policy. All settings need to be
specified manually, excluding the ones in
the Auto policy settings section of this
table.