User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
18
2
2. Overview of the Configuration
Commands
This chapter provides an overview of all configuration commands in the five configuration
command modes. The keywords and associated parameters that are available for these
commands are explained in the following chapters. The chapter includes the following sections:
• Network Settings (Net Mode) Configuration Commands
• Security Settings (Security Mode) Configuration Commands
• Administrative and Monitoring Settings (System Mode) Configuration Commands
• Wireless Settings (Dot11 Mode) Configuration Commands
• VPN Settings (VPN Mode) Configuration Commands
Network Settings (Net Mode) Configuration Commands
Enter the net ? command at the CLI prompt to display the description of all the
configuration commands in the net mode. The following table lists the commands in
alphabetical order:
Table 7. Net mode configuration commands
Submode Command Name Purpose
ddns net ddns configure Enable, configure, or disable Dynamic
DNS (DDNS) service.
dmz
net dmz ipv4 configure Enable, configure, or disable the IPv4
DMZ.
net dmz ipv6 configure Enable, configure, or disable the IPv6
DMZ.
net dmz ipv6 pool configure Configure a new or existing IPv6 DMZ
DHCP address pool.
ethernet net ethernet configure <interface name or number> Configure a VLAN for a LAN interface.
ipv6 net ipv6 ipmode configure Configure the IP mode (IPv4 only or
IPv4/IPv6).