User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Dot11 Mode Configuration Commands
174
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
dot11-config[profile]>
wpa authentication PSK
dot11-config[profile]>
wpa wpa_password Se36cu37re38!
dot11-config[profile]>
enable_active_time Y
dot11-config[profile]>
start hour 8
dot11-config[profile]>
start meridiem AM
dot11-config[profile]>
start minute 00
dot11-config[profile]>
stop hour 5
dot11-config[profile]>
stop meridiem PM
dot11-config[profile]>
stop minute 00
dot11-config[profile]>
wlan_partition N
dot11-config[profile]>
save
Related show command: show dot11 profile [profile name] and show dot11 profile status <profile
name>
dot11 profile delete <profile name>
This command deletes a profile by deleting its name. You cannot delete the default profile
(default1).
Related show command: show dot11 profile [profile name]
dot11 profile disable <profile name>
This command disables a profile by specifying its name.
Related show command: show dot11 profile [profile name]
dot11 profile enable <profile name>
This command enables a profile by specifying its name.
Format dot11 profile delete <profile name>
Mode dot11
Format dot11 profile disable <profile name>
Mode dot11
Format dot11 profile enable <profile name>
Mode dot11