User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Dot11 Mode Configuration Commands
171
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
dot11-config[radio-advance]>
power_save_enable Y
dot11-config[radio-advance]>
save
Related show command: show dot11 radio
Wireless Profile Commands
dot11 profile configure <profile name>
This command configures a new or existing profile. After you have issued the dot11
profile configure command to specify the name of a profile, you enter the dot11-config
[profile] mode, and then you can configure one keyword and associated parameter or
associated keyword at a time in the order that you prefer.
Step 1 Format dot11 profile configure <profile name>
Mode dot11
Step 2 Format ssid <ssid name>
broadcast-ssid {Y | N}
security_type {Open | WEP | WPA | WPA2 | WPA+WPA2}
vlan_profile <vlan name>
wep authentication {Automatic | Open-System | Shared-Key}
wep encryption {64-bit-WEP | 128-bit-WEP}
wep {passphrase {{1 | 2 | 3 | 4} <passphrase>} | wep key
{{1 | 2 | 3 | 4} <key>}}
wpa encryption {TKIP | CCMP | TKIP+CCMP}
wpa authentication {PSK {wpa wpa-password <password>} | RADIUS |
PSK+RADIUS {wpa wpa_password <password>}}
pre-authentication {Y | N}
e
nable_active_time {N | Y {start hour <hour>} {start meridiem
{AM | PM}} {start minute <minute>} {stop hour <hour>}
{stop meridiem {AM | PM}} {stop minute <minute>}}
wlan_partition {Y | N}
Mode dot11-config [profile]
Keyword (might consist
of two separate words)
Associated Keyword to Select
or Parameter to Type
Description
ssid ssid name The name of the 802.11 profile SSID.
broadcast_ssid Y or N Enables or disables the SSID broadcast.