User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
System Mode Configuration Commands
159
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Command example:
FVS318N>
system logging configure
system-config[logging-ipv4-ipv6]>
lan_wan_drop_packet_logs Y
system-config[logging-ipv4-ipv6]>
wan_lan_drop_packet_logs Y
system-config[logging-ipv4-ipv6]>
change_of_time_by_NTP_logs Y
system-config[logging-ipv4-ipv6]>
secure_login_attempts_logs Y
system-config[logging-ipv4-ipv6]>
reboot_logs Y
system-config[logging-ipv4-ipv6]>
unicast_traffic_logs Y
system-config[logging-ipv4-ipv6]>
bandwidth_limit_logs Y
system-config[logging-ipv4-ipv6]>
save
Related show command: show system logging setup and show system logs
system logging remote configure
This command configures email logs and alerts, schedules email logs and alerts, and
configures a syslog server. After you have issued the system logging remote
configure command, you enter the system-config [logging-remote] mode, and then you
can configure one keyword and associated parameter or associated keyword at a time in the
order that you prefer.
Other event logs
source_mac_filter_logs Y or N Enables or disables logging of packets
from MAC addresses that match the
source MAC address filter settings.
session_limit_logs Y or N Enables or disables logging of packets
that are dropped because the session
limit has been exceeded.
bandwidth_limit_logs Y or N Enables or disables logging of packets
that are dropped because the
bandwidth limit has been exceeded.
Step 1 Format system logging remote configure
Mode system
Step 2 Format log_identifier <identifier>
Keyword Associated
Keyword to Select
Description