User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
System Mode Configuration Commands
154
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Command example:
FVS318N>
system time configure
system-config[time]>
timezone GMT-08:00::Pacific-Time-Canada--Pacific-Time-US
system-config[time]>
auto_daylight Y
system-config[time]>
use_default_servers Y
system-config[time]>
save
Related show command: show system time setup
Traffic Meter Command
system traffic_meter configure
This command configures the traffic meter. After you have issued the system
traffic_meter configure command, you enter the system-config [traffic-meter] mode,
and then you can configure one keyword and associated parameter or associated keyword at
a time in the order that you prefer.
GMT+13:00::Tonga
GMT+14:00::Kiribati
Step 1 Format system traffic_meter configure
Mode system
Step 2 Format enable {Y | N}
limit_type {Nolimit | Downloadonly | BothDirections}
monthly_limit <number>
increase_limit_enable {N | Y {increase_limit_by <number>}}
counter {RestartCounter | SpecificTime {day_of_month <day>}
{time_hour <hour>} {AM | PM} {time_minute <minute>}}
send_email_report {Y | N}
Table 12. Timezone keywords (continued)
GMT time and location
Note: Enter the keywords exactly as stated (you can use autocompletion keys). If
there are two locations for the same time zone, enter the location exactly as stated.
For example, either enter GMT-11:00::Samoa or enter GMT-10:00::Hawaii.