User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
System Mode Configuration Commands
150
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
system snmp trap delete <ipaddress>
This command deletes an SNMP agent by deleting its IP address.
Related show command: show system snmp trap [agent ipaddress]
system snmp sys configure
This command configures the SNMP system information. After you have issued the system
snmp sys configure command, you enter the system-config [snmp-system] mode, and
then you can configure one keyword and associated parameter or associated keyword at a
time in the order that you prefer.
Command example:
FVS318N>
system snmp sys configure
system-config[snmp-system]>
sys-contact AdminFVS@netgear.com
system-config[snmp-system]>
sys-location San Jose
system-config[snmp-system]>
sys-name FVS318N-Bld3
system-config[snmp-system]>
save
Related show command: show system snmp sys
Format system snmp trap delete <ipaddress>
Mode system
Step 1 Format system snmp sys configure
Mode system
Step 2 Format sys-contact <contact name>
sys-location <location name>
sys-name <system name>
Mode system-config [snmp-system]
Keyword Associated
Parameter to Type
Description
sys-contact contact name The system contact name (alphanumeric string).
sys-location location name The system location name (alphanumeric string).
sys-name system name The system name (alphanumeric string).