User's Manual
Table Of Contents
- ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
- Contents
- 1. Introduction
- 2. Overview of the Configuration Commands
- 3. Net Mode Configuration Commands
- 4. Security Mode Configuration Commands
- Security Services Commands
- Security Schedules Commands
- IPv4 Add Firewall Rule and Edit Firewall Rule Commands
- IPv4 General Firewall Commands
- IPv6 Firewall Commands
- Attack Check Commands
- Session Limit, Time-Out, and Advanced Commands
- Address Filter and IP/MAC Binding Commands
- Port Triggering Commands
- UPnP Command
- Bandwidth Profile Commands
- Content Filtering Commands
- 5. System Mode Configuration Commands
- 6. Dot11 Mode Configuration Commands
- 7. VPN Mode Configuration Commands
- IPSec VPN Wizard Command
- IPSec IKE Policy Commands
- IPSec VPN Policy Commands
- IPSec VPN Mode Config Commands
- SSL VPN Portal Layout Commands
- SSL VPN Authentication Domain Commands
- SSL VPN Authentication Group Commands
- SSL VPN User Commands
- SSL VPN Port Forwarding Commands
- SSL VPN Client Commands
- SSL VPN Resource Commands
- SSL VPN Policy Commands
- RADIUS Server Command
- L2TP Server Commands
- 8. Overview of the Show Commands
- 9. Show Commands
- 10. Utility Commands
- CLI Command Index
Security Mode Configuration Commands
121
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Command example: See the command example for the security firewall ipv6 configure command.
Related show command: show security firewall ipv6 setup
security firewall ipv6 delete <row id>
This command deletes an IPv6 firewall rule by deleting its row ID.
Related show command: show security firewall ipv6 setup
destination_address_type ANY, SINGLE_ADDRESS, or
ADDRESS_RANGE
The type of destination address.
destination_start_address ipv6-address There are two options:
• The IPv6 address if the
destination_address_type
keyword is set to
SINGLE_ADDRESS.
• The start IPv6 address if the
destination_address_type
keyword is set to
ADDRESS_RANGE.
destination_end_address ipv6-address The end IPv6 address if the
destination_address_type
keyword is set to
ADDRESS_RANGE.
QoS profile and logging
qos_priority Normal-Service, Minimize-Cost,
Maximize-Reliability,
Maximize-Throughput, or
Minimize-Delay
The type of QoS that applies to
the rule. You can apply QoS to
LAN WAN and DMZ WAN
outbound rules only.
log NEVER or ALWAYS Enables or disables logging.
Format security firewall ipv6 delete <row id>
Mode security
Keyword (might consist of two
separate words)
Associated Keyword to Select or
Parameter to Type
Description