User's Manual

Security Mode Configuration Commands
118
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Command example:
FVS318N> security firewall ipv6 configure
security-config[firewall-ipv6]> from_zone WAN
security-config[firewall-ipv6]> to_zone LAN
security-config[firewall-ipv6]> service_name default_services RTELNET
security-config[firewall-ipv6]> action ALWAYS_ALLOW
security-config[firewall-ipv6]> source_address_type SINGLE_ADDRESS
security-config[firewall-ipv6]> source_start_address 2002::B32:AAB1:fD41
security-config[firewall-ipv6]> destination_address_type SINGLE_ADDRESS
security-config[firewall-ipv6]> destination_start_address FEC0::db8:145
security-config[firewall-ipv6]> log ALWAYS
security-config[firewall-ipv6]> save
Related show command: show security firewall ipv6 setup
security firewall ipv6 edit <row id>
This command configures an existing IPv6 firewall rule. After you have issued the security
firewall ipv6 edit command to specify the row to be edited (for row information, see
destination_address_type ANY, SINGLE_ADDRESS, or
ADDRESS_RANGE
The type of destination address.
destination_start_address ipv6-address There are two options:
• The IPv6 address if the
destination_address_type
keyword is set to
SINGLE_ADDRESS.
• The start IPv6 address if the
destination_address_type
keyword is set to
ADDRESS_RANGE.
destination_end_address ipv6-address The end IPv6 address if the
destination_address_type
keyword is set to
ADDRESS_RANGE.
QoS profile and logging
qos_priority Normal-Service, Minimize-Cost,
Maximize-Reliability,
Maximize-Throughput, or
Minimize-Delay
The type of QoS that applies to
the rule. You can apply QoS to
LAN WAN and DMZ WAN
outbound rules only.
log NEVER or ALWAYS Enables or disables logging.
Keyword (might consist of two
separate words)
Associated Keyword to Select or
Parameter to Type
Description