User's Manual

Security Mode Configuration Commands
115
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
security firewall ipv4 disable <row id>
This command disables an IPv4 firewall rule by specifying its row ID.
Related show command: show security firewall ipv4 setup lan_wan, show security firewall ipv4 setup
dmz_wan, and show security firewall ipv4 setup lan_dmz
security firewall ipv4 enable <row id>
This command enables an IPv4 firewall rule by specifying its row ID.
Related show command: show security firewall ipv4 setup lan_wan, show security firewall ipv4 setup
dmz_wan, and show security firewall ipv4 setup lan_dmz
IPv6 Firewall Commands
security firewall ipv6 default_outbound_policy {Allow | Block}
This command allows or blocks the IPv6 firewall default outbound policy.
Related show command: show security firewall ipv6 setup
security firewall ipv6 configure
This command configures a new IPv6 firewall rule. After you have issued the security
firewall ipv6 configure command, you enter the security-config [firewall-ipv6] mode,
and then you can configure one keyword and associated parameter or associated keyword at
a time in the order that you prefer. However, note that the setting of the action keyword
determines which other keywords and parameters you can apply to a rule.
Format security firewall ipv4 disable <row id>
Mode security
Format security firewall ipv4 enable <row id>
Mode security
Format security firewall ipv6 default_outbound_policy {Allow | Block}
Mode security