User's Manual

Reference Manual for the Model FVM318 Cable/DSL ProSafe Wireless VPN Security Firewall
Connecting the Firewall to the Internet 2-17
Configuring Wireless Connectivity
Use the procedure below to configure an Internet connection via the serial port of your firewall.
Procedure 2-8: Serial Port Internet Connection Configuration
There are three steps to configuring the serial port of your firewall for an Internet connection:
1. Connect the firewall to your ISDN or dial-up analog modem
2. Configure the firewall
3. Connect to the Internet
Follow the steps below to configure a serial port Internet connection on your firewall.
1. Connect the Firewall to your ISDN or dial-up modem
a. Turn off your Modem and connect the cable (C) from your FR328S’s serial port to the
modem.
Figure 2-12: Connect the ISDN or analog modem to the firewall
b. Turn on the modem and wait about 30 seconds for the lights to stop blinking.
MODEM
12VDC O.5A
87654321
LO CA L
10/100M
IN TERN ET
ISDN or
analog modem
C
FVM318.book Page 17 Wednesday, September 18, 2002 5:20 PM