User's Manual

Reference Manual for the Model FVM318 Cable/DSL ProSafe Wireless VPN Security Firewall
1-6 Introduction
These LEDs are green when lit, except for the TEST LED, which is amber.
The Firewall’s Rear Panel
The rear panel of the FVM318 (Figure 1-2) contains the connections identified below.
Figure 1-2: FVM318 Rear Panel
Viewed from left to right, the rear panel contains the following elements:
• DB-9 serial port for modem connection
• Factory Default Reset push button
• Eight Local Ethernet RJ-45 ports for connecting the firewall to the local computers
• Internet WAN Ethernet RJ-45 port for connecting the firewall to a cable or DSL modem
• AC power adapter input
Table 1-1: LED Descriptions
Label Activity Description
POWER On Power is supplied to the firewall.
TEST On
Off
The system is initializing.
The system is ready and running.
MODEM On/Blinking The port detected a link with the Internet WAN connection or
Remote Access Server. Blinking indicates data transmission.
INTERNET
100 On/Blinking The Internet port is operating at 100 Mbps.
LINK/ACT (Activity) On/Blinking The port detected a link with the Internet WAN connection and is
operating at 10 Mbps. Blinking indicates data transmission.
LOCAL
100 On/Blinking The Local port is operating at 100 Mbps.
LINK/ACT
(Link/Activity)
On/Blinking The Local port has detected a link with a LAN connection and is
operating at 10 Mbps. Blinking indicates data transmission.
MODEM
12VDC O.5A
87654321
LO C A L
10/100M
IN TERN ET
FVM318.book Page 6 Wednesday, September 18, 2002 5:20 PM