Quick Reference Guide

ManualsBrandsNetgear ManualsPC ComponentsNetgear FVM318

Reference Manual for the Model FVM318 Cable/DSL ProSafe Wireless VPN Security Firewall

5-4 Virtual Private Networking

Procedure 5-1: Configuring a Network to Network VPN Tunnel

Follow this procedure to configure a VPN tunnel between two LANs via a FVM318 at each end.

Figure 5-2: LAN to LAN VPN access from an FVM318 to an FVM318

The sample configuration worksheet below is filled in with the parameters used in this procedure.

A blank worksheet is provided on page 5-22.

Network to Network VPN Tunnel Configuration Worksheet

IKE Tunnel Security Association Settings

Connection Name: VPNAB

Local IPSec Identifier

LAN A:

LAN_A

LAN B

LAN_B

PreShared Key: r>T(h4&3@#kB

Secure Association -- Main Mode or Aggressive Mode: Main

Perfect Forward Secrecy: Enabled

WAN Encryption Protocol:

DES, 3DES, or AES -128, -192, or -256

DES

Wireless Encryption Protocol:

-- IPSec (DES, 3DES, or AES -128, -192, or -256)

-- WEP (64-bit or 128-bit)

N/A

Key Life in seconds: 3600 (1 hour)

IKE Life Time in seconds: 28800 (8 hours)

FVM318 Network IP Settings

Network LAN IP Network Address Subnet Mask Gateway IP (WAN IP Address)

LAN A 192.168.3.1 255.255.255.0 24.0.0.1

LAN B 192.168.0.1 255.255.255.0 10.0.0.1

LAN A

192.168.3.1

192.168.0.1

INTERN ET LOCAL

ACT

12345 678

LNK

LNK/ACT

100

Cable/DSL

ProSafeWireless VPNSecurity Firewall

MODEL

FVM318

PWR TEST

WLAN

Enable