Quick Reference Guide

Model FVL328 ProSafe High-Speed VPN Firewall Reference Manual Revision 2
Virtual Private Networking 6-21
May 2004, 202-10030-02
FVL328 Scenario 1: How to Configure the IKE and VPN Policies
Note: This scenario assumes all ports are open on the FVL328. You can verify this by reviewing
the security settings as seen in the Rules menu.
Use this scenario illustration and configuration screens as a model to build your configuration.
Figure 6-11: LAN to LAN VPN access from an FVL328 to an FVL328
1. Log in to the FVL328 labeled Gateway A as in the illustration.
Log in to the firewall at its default LAN address of http://192.168.0.1 with its default user
name of
admin and default password of password, or using whatever Password and LAN
address you have chosen for the firewall.
2. Configure the WAN (Internet) and LAN IP addresses of the FVL328.
a. From the main menu Setup section, click the Basic Settings link.
Note: If you have turned NAT off, before configuring VPN IPSec tunnels you must first
open UDP port 500 for inbound traffic as explained in “Example: Port Forwarding for
VPN Tunnels when NAT is Off” on page 5-9.
Gateway B
FVL328
Scenario 1
14.15.16.17 22.23.24.25
WAN IP
WAN IP
172.23.9.1/2410.5.6.1/24
LAN IP
LAN IP
Gateway A