Quick Reference Guide

Model FVL328 ProSafe High-Speed VPN Firewall Reference Manual Revision 2
Introduction 2-7
May 2004, 202-10030-02
You can use some of the LEDs to verify connections. Table 2-1 lists and describes each LED on
the front panel of the firewall. These LEDs are green when lit, except for the TEST LED, which is
amber.
The Firewall’s Rear Panel
The rear panel of the FVL328 (Figure 2-2) contains the connections identified below.
Figure 2-2: FVL328 Rear Panel
Viewed from left to right, the rear panel contains the following elements:
• Factory Default Reset push button
• Eight Local Ethernet RJ-45 ports for connecting the firewall to local computers
• Internet WAN Ethernet RJ-45 port for connecting the firewall to a broadband modem
• AC power adapter input
Table 2-1: LED Descriptions
Label Activity Description
POWER On Power is supplied to the firewall.
TEST On
Off
The system is initializing.
The system is ready and running.
Internet
100 On/Blinking The Internet port is operating at 100 Mbps.
LINK/ACT (Activity) On/Blinking The port detected a link with the Internet WAN connection and is
operating at 10 Mbps. Blinking indicates data transmission.
LOCAL
100 On/Blinking The Local port is operating at 100 Mbps.
LINK/ACT
(Link/Activity)
On/Blinking The Local port has detected a link with a LAN connection and is
operating at 10 Mbps. Blinking indicates data transmission.