Manualshelf

Quick Start Manual

ManualsBrandsNetgear ManualsHubsNetgear FS752TP
11121314151617181920
Physical Description
12
FS752TP Smart Switch
LED Designations
The front panel supports a number of LEDs that indicate basic status of the unit and
individual ports, and are intended to assist in local fault diagnosis.
System LEDs
The System LEDs are located on the left side of the front panel.
Power LEDs
The Power LED is a bi-color LED that serves as an indicator of power and diagnostic statues.
The following indications are given by the LED state.
LED Designation
Power • Solid Green — Device is powered on, run-time code is up and running.
• Solid Yellow — System is in the bootup stage.
• Off — Power is not supplied to the device.
Fan LED
The Fan LED is a yellow LED that indicates the fan status. The following indications are given
by the LED state.
LED Designation
Fan • Solid Yellow — Fan has failed.
• Off — Fan operating normally.
Max PoE LED
The following indications are given by the LED state.
LED Designation
Max PoE • Solid Yellow— Indicates less than 7 watts of power is available.
• Blinking Yellow — Indicates the PoE MAX LED was active in the previous two
minutes.
• Off — There is at least 7 watts of PoE power available for another device.
LED Mode LED
The following indications are given by the LED state.