User Manual
Table Of Contents
- FS728TP Smart Switch
- Table of Contents
- 1. Getting Started
- Getting Started with the FS728TP Smart Switch
- Switch Management Interface
- Connecting the Switch to the Network
- Switch Discovery in a Network with a DHCP Server
- Switch Discovery in a Network without a DHCP Server
- Configuring the Network Settings on the Administrative System
- Web Access
- Smart Control Center Utilities
- Understanding the User Interfaces
- Interface Naming Convention
- 2. Configuring System Information
- 3. Configuring Switching Information
- 4. Configuring Quality of Service
- 5. Managing Device Security
- 6. Monitoring the System
- 7. Maintenance
- 8. Help
- A. Hardware Specifications and Default Values
- B. Configuration Examples
- C. Notification of Compliance
- Index
150 | Chapter 5: Managing Device Security
FS728TP Smart Switch Software Administration Manual
To display the TACACS+ Server Configuration page, click Security Management Security,
and then click the TACACS+ Server Configuration link.
To configure TACACS+ server settings:
1. To add a new TACACS+ server, select Add from the TACACS+ Server field, enter the
IP address of the server to add, and click Apply.
Note: The Add option is available if fewer than five TACACS+ servers are
configured on the system, and the Server Address field is only
available when Add is selected in the TACACS+ Server IP Address
field.
After you add one or more TACACS+ servers, additional fields appear on the TACACS+
Server Configuration page.
2. In the Priority field, specify the order in which the TACACS+ servers are used. A value of 0
is the highest priority.
3. In the Port field, specify the authentication port number through which the TACACS+
session occurs. The default is port 49, and the range is 0–65535.
4. In the Key String field, specify the authentication and encryption key for TACACS+
communications between the FS728TP and the TACACS+ server. This key must match the
encryption used on the TACACS+ server. The valid range is 0–128 characters.