User Manual
Table Of Contents
- FS728TP Smart Switch
- Table of Contents
- 1. Getting Started
- Getting Started with the FS728TP Smart Switch
- Switch Management Interface
- Connecting the Switch to the Network
- Switch Discovery in a Network with a DHCP Server
- Switch Discovery in a Network without a DHCP Server
- Configuring the Network Settings on the Administrative System
- Web Access
- Smart Control Center Utilities
- Understanding the User Interfaces
- Interface Naming Convention
- 2. Configuring System Information
- 3. Configuring Switching Information
- 4. Configuring Quality of Service
- 5. Managing Device Security
- 6. Monitoring the System
- 7. Maintenance
- 8. Help
- A. Hardware Specifications and Default Values
- B. Configuration Examples
- C. Notification of Compliance
- Index
118 | Chapter 3: Configuring Switching Information
FS728TP Smart Switch Software Administration Manual
To configure the Dynamic Address setting:
1. Specify the number of seconds the forwarding database should wait before deleting a
learned entry that has not been updated. IEEE 802.1D-1990 recommends a default of
300 seconds. You may enter any number of seconds between 10 and 1000000. The
factory default is 300.
Note: IEEE 802.1D recommends a default of 300 seconds, which is the
factory default.
2. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
3. Click Apply to apply to send the updated configuration to the switch. Configuration changes
take effect immediately.
Static MAC Address
Use the Static MAC Address Configuration page to configure and view static MAC addresses
on an interface.
To access the Static MAC Address Configuration page, click Switching Address Table
Advanced Static MAC Address.