User Manual
Table Of Contents
- FS728TP Smart Switch
- Table of Contents
- 1. Getting Started
- Getting Started with the FS728TP Smart Switch
- Switch Management Interface
- Connecting the Switch to the Network
- Switch Discovery in a Network with a DHCP Server
- Switch Discovery in a Network without a DHCP Server
- Configuring the Network Settings on the Administrative System
- Web Access
- Smart Control Center Utilities
- Understanding the User Interfaces
- Interface Naming Convention
- 2. Configuring System Information
- 3. Configuring Switching Information
- 4. Configuring Quality of Service
- 5. Managing Device Security
- 6. Monitoring the System
- 7. Maintenance
- 8. Help
- A. Hardware Specifications and Default Values
- B. Configuration Examples
- C. Notification of Compliance
- Index
Chapter 3: Configuring Switching Information | 107
FS728TP Smart Switch Software Administration Manual
3. To configure IGMP Snooping settings for both physical ports and LAGs, click ALL.
4. Select the check box next to the port or LAG to configure. You can select multiple ports and
LAGs to apply the same setting to the selected interfaces. Select the check box in the
heading row to apply the same settings to all interfaces.
5. Configure the IGMP Snooping values for the selected port(s) or LAG(s):
• Admin Mode. Select the interface mode for the selected interface for IGMP Snooping
for the switch from the menu. The default is Disable.
• Host Timeout. Specify the amount of time you want the switch to wait for a report for
a particular group on a particular interface before it deletes that interface from the
group. Enter a value between 2 and 3600 seconds. The default is 260 seconds.
• Max Response Time. Specify the amount of time you want the switch to wait after
sending a query on an interface because it did not receive a report for a particular
group on that interface. Enter a value greater or equal to 1 and less than the Host
Timeout, in seconds. The default is 10 seconds.
• MRouter Timeout. Specify the amount of time you want the switch to wait to receive
a query on an interface before removing it from the list of interfaces with multicast
routers attached. Enter a value between 0 and 3600 seconds. The default is 0
seconds. A value of zero indicates an infinite timeout; no expiration.
• Fast Leave Admin Mode. Select the Fast Leave mode for a particular interface from
the menu. The default is Disable.
6. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
7. If you make any configuration changes, click Apply to apply the new settings to the switch.
Configuration changes take effect immediately.
IGMP Snooping Table
Use the IGMP Snooping Table page to view all of the entries in the Multicast Forwarding
Database that were created for IGMP snooping.
To access the IGMP Snooping Table page, click Switching Multicast IGMP Snooping
IGMP Snooping Table.