Owner's Manual

19.
Reconnect
your
WiFi-enabled device
to
the
new extender
WiFi
network.
20.
Test
the
new extended
WiFi
range by moving
your
WiFi-enabled
device
to
the
area
with
a poor router WiFi
signal:
a.
Leave
your
WiFi-enabled
device
in
the
area
with
a poor router
WiFi
signal
and return
to
the
extender.
b.
Check
the
Client
Link
LED
(<
>)
on
the
extender:
•
If
the
Client Link
LED
is
solid green
or
amber,
your
new
extender WiFi
network
reaches
the
area
with
a poor router
WiFi
signal
and
your
network
setup
is
complete.
If
the
Client
Link
LED
is
red,
your
new extender WiFi
network
does
not
reach
the
area
with
a poor router WiFi
signal.
You
must move
your
WiFi-enabled
device closer
to
the
extender until
the
Client
Link
LED
turns solid green
or
amber.
Connect
an
Ethernet-
Enabled Device
After
the
extender
is
connected
to
your
existing WiFi network, you
can
connect a wired device
to
the
extender using
an
Ethernet
cable.
That
device
can
then access
your
existing
network
through
the
WiFi connection.
trr
Router
12