Owner's Manual
Table Of Contents
- Quick Start Guide
- Range Extender User Manual
- Table of Contents
- Overview
- Get Started
- Optimize Extender Performance
- Extender Network Settings
- View Connected Devices
- View WiFi Settings
- Change the WiFi Network Name
- Turn Off the SSID Broadcast to Create a Hidden Network
- Disable or Enable the WiFi Radios
- Change the WiFi Speed
- Use WPS to Add a Computer to the Extender’s WiFi Network
- Deny Access to a Computer or WiFi Device
- Set Up an Access Schedule
- Change the Extender’s Device Name
- Set Up the Extender to Use a Static IP Address
- Maintain and Monitor the Extender
- Change the Extender User Name and Password
- Turn Password Protection Off and On
- Recover a Forgotten User Name or Password
- Automatically Adjust for Daylight Saving Time
- Manually Set the Extender Clock
- Back Up and Manage the Extender Configuration
- Back Up the Configuration Settings
- Return the Extender to Its Factory Default Settings
- Update the Firmware
- Turn the NETGEAR Logo LED On or Off
- Restart the Extender Remotely
- Share a USB Storage Device
- Use the Extender as a Media Server
- Share a USB Printer Through the Extender
- FAQs and Troubleshooting
- Factory Settings and Technical Specifications
Overview
9
AC1900 WiFi Range Extender
Rear Panel
The following figure shows the ports, buttons, antennas, and connector on the rear panel of
the extender.
Reset button
Ethernet LAN
Power connector
Power On/Off
WPS button
button
ports (5)
Antennas
Figure 2. Rear panel
Attach the Stand
If you prefer to place the extender in the upright (vertical) position, attach the stand that
comes with the extender.
To attach the stand:
1. Place the stand on a flat surface.
2. Hold the extender in upright position with
the left side of the extender pointing down.
The left side is the one with three
rectangular openings.
The top panel of the extender and the
three vertical support posts of the stand
must face the same direction.
3. Lower the extender onto the stand until the
support posts of the stand snap into the
rectangular openings of the extender.