Operation Manual

Get Started
12
AC750 WiFi Range Extender
9. Test the extender WiFi range by moving your WiFi-enabled computer or mobile device to the
area with a poor router WiFi signal:
a. Leave your WiFi-enabled computer or mobile device in the area with a poor router
WiFi signal and return to the extender
.
b. Check the Client Link LED
on the extender:
• If the Client Link LED is solid green or amber
, your extender WiFi network reaches
the area with a poor router WiFi signal and your network setup is complete.
• If the Client Link LED is red, your extender WiFi network does not reach the area
with a poor router WiFi signal.
You must move the WiFi-enabled computer or mobile device closer to the
extender until the Client Link LED turns solid green or amber
.
Connect With the NETGEAR Installation Assistant
 To connect with the NETGEAR installation assistant:
1. Use a WiFi network manager on a WiFi-enabled computer or mobile device to find and
connect to the extender WiFi network EX6100_NETGEAR_2EXT
.
After the connection with the WiFi-enabled computer or mobile device is established, the
Client Link LED lights.
2. Launch a web browser
.
3. Enter www
.mywifiext.net in the address field of the browser.
The New Extender Setup page displays.
4. Click the NEW EXTENDER SETUP button.
5. Complete the fields on the page and click the NEXT button.
6. V
erify that the Access Point/Extender switch is set to Extender and click the
CONTINUE button.
7. Select a WiFi network to extend and click the NEXT button.