Operation Manual
Table Of Contents
- AC750 WiFi Range Extender
- Contents
- 1. Get to Know Your Extender
- 2. Install Your Extender
- 3. Manage the Extender Network and Settings
- Log In After Initial Setup
- Change the admin Password
- Set Up Password Recovery for admin
- Use Smart Setup to Connect the Extender to a Network
- Add a WPS Client to the Extender Network
- Change the Basic WiFi Settings
- Change WiFi Security Settings
- View or Change Advanced Wireless Settings
- View or Change the WPS Settings
- Set Up a Wireless Access List
- View or Change the Internet IP Address Setting
- Enable NAT in the Extender
- Manage Profiles
- Operating Mode
- 4. Monitor and Maintain the Extender
- 5. FAQs and Troubleshooting
- A. Supplemental Information
Get to Know Your Extender
8
AC750 WiFi Range Extender
Use as an Access Point
You can connect the extender to your router or gateway with a wired connection and use the
extender as an 11ac access point.
Figure 3. Extender as an access point
Support for the 802.11ac Networking Standard
The extender supports the 802.11ac networking standard. This new standard offers better
speed, improved reliability, and more range than older WiFi networking standards. The
extender is backward compatible with earlier WiFi standards. However, to get the benefits of
802.11ac, your wireless router must support the 802.11ac WiFi networking standard.
To learn more about the 802.11ac WiFi networking standard, visit
http://www.netgear.com/landing/80211ac/.
Figure 4. Speed comparison between the 802.11n and 802.11ac standards