Quick Start Manual

Installation Guide for the Model EN516 Ethernet Hub
C-4 Connector Pin Assignments
BNC T-Connector and 50 Ω Terminator
The BNC port on the Model EN516 hub, with the BNC T-connector and the 50 Ω terminator, is
used for connecting to a thin coaxial segment. Figure C-4 illustrates the BNC T-connector and
50 Ω terminator. For information on connecting to the BNC port, refer to Chapter 3, “Installation,”
and Appendix B, “Cabling Specifications.”
Figure C-4. 50 Ω terminator and BNC T-connector
7178
50
OHM