Quick Start Manual

Connector Pin Assignments C-1

Appendix C

Connector Pin Assignments

This appendix provides information on the RJ-45, AUI, and BNC connectors that are used for the

NETGEAR Model EN516 Ethernet Hub.

RJ-45 Connector

The RJ-45 connector is used to connect workstations, hubs, and switches through unshielded

twisted pair cable. The RJ-45 connector accepts four-pair Category 3 or Category 5 UTP cable.

Only two pairs are used for 10BASE-T wiring. Figure C-1 illustrates the RJ-45 connector.

Figure C-1. RJ-45 connector

7177