Quick Start Manual

Installation Guide for the Model EN516 Ethernet Hub
3-2 Installation
• AC power cord
• Rack mount kit
• Four rubber pads for installation on a flat surface
• One BNC T-connector
• One BNC terminator
• Warranty and Owner Registration Card
Call your dealer if there are any wrong, missing, or damaged parts. Keep the carton, including the
original packing materials. Use them to repack the hub if there is a need to return it for repair.
Be sure to complete the Owner Registration Card and return it to NETGEAR to qualify for product
updates and product warranty registration.
Required Tools
To install the hub on a flat surface, you do not need any special tools. However, to install the hub in
a rack, you need the following tools:
• #1 Phillips screwdriver to attach mounting brackets
• #2 Phillips screwdriver to tighten mounting screws
Installing the Hub
To install the Model EN516 hub, follow these steps:
1.
Unpack the hub.
2.
Choose a location near the devices to be connected and close to an electrical outlet.
3.
Follow the instructions for installing the hub on a flat surface or in a rack.
Caution:
Use the appropriate power cord as required by your national electrical codes
and ordinances.