Quick Start Manual

Model EN308
TC
Ethernet Hub Installation Guide
Product Illustration
Front Panel
The front panel of the Model EN308
TC
hub contains LEDs that monitor the
activity status of the hub.
For ease of use, the front panel 10BASE-T LEDs that indicate link, receive, or
partition activity are duplicated on the 10BASE-T ports on the rear panel. Use
the rear panel LEDs when setting up the device, and use the same LEDs on the
front panel for monitoring the ports when the hub is positioned in place and set
up.
Front Panel LEDs
The table below describes the activity of the front panel LEDs.
Label
Color Activity Description
Pwr (Power) Green On Power is supplied to the hub.
Col (Collision) Amber Blinking Data collision is occurring on the network. Note
that occasional collisions are normal.
10BASE-T
LEDs
Link/Receive
(For ports 1
through 8)
Green On The link between this port and the connected
port is good.
Blinking There is incoming data on the port.
Partition Amber On The port is partitioned because of excessive
collisions.
BNC LEDs
Rx Green Blinking There is incoming data on the BNC port.
Partition Green On The BNC port is partitioned because of
excessive collisions.
9117FA
PWR COL
1
234
On=Link, Blinking=Receive
Partition
5678
EN308TC
MODEL
PORT
10 Mbps
Ethernet Hub
8
Rx
Partition
COL
(Collision)
LED
PWR
(Power)
LED
BNC Partition
LED
BNC Rx
LED
10BASE-T
LEDs
Product Illustration