Quick Start Manual

Getting to Know Your Wireless Router 7
To use the WPS method to implement security, see “Using Push 'N' Connect (WPS) to
Configure Your Wireless Network” on page 24.
To turn the antenna display lights on or off:
1.
Tap the dome for less than 2 seconds. If lights are off, they will turn on.
2. Tap the dome for less than 2 seconds. If lights are on, they will turn off.
Router Label
The label on the back of the modem router shows the router’s MAC address, serial number,
security PIN, and factory default login information. The ports are color-coded to distinguish your
Internet port from the other four ports that connect to the wired computer(s) on your LAN. The
label will be similar to the one shown in the following figure:
Before using these Wi-Fi Protected Setup (WPS) push-button procedures, verify
that your device (a notebook, adapter, or other device) supports WPS.
Figure 5