Owner's Manual

150 | Appendix B. NETGEAR VPN Configuration
N300 Wireless ADSL2+ Modem Router DGN2200
Verify that the firmware is up to date, and make sure you have all the addresses and
parameters to be set on both sides. Assure that there are no firewall restrictions
Table 13.
VPN Consortium Scenario Scenario 1
Type of VPN: PC/client-to-gateway, with client behind NAT router
Security scheme: IKE with pre-shared secret/key (not certificate based)
IP addressing:
Gateway Fully qualified domain name (FQDN)
Client Dynamic
.
Gateway A
(main office)
Gateway B
LAN IP
192.168.0.1
192.168.0.1/24
FQDN
ntgr.dyndns.org
“from_GW_A”
WAN IP
Internet
WAN IP
0.0.0.0
“toGW_A”
IP: 192.168.2.3
(regional office)
Client PC
(running NETGEAR
ProSafe VPN client)
Figure 30. Telecommuter Example
Setting Up Client-to-Gateway VPN Configuration
(Telecommuter Example)
Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN Client and a
network gateway involves two steps:
• Step 1: Configure Gateway A (the NETGEAR VPN Router at the Main Office) on
page 151.
• Step 2: Configure Gateway B (the Modem Router at the Regional Office) on page 152
describes configuring the NETGEAR ProSafe VPN Client endpoint.