Owner's Manual

Appendix B. NETGEAR VPN Configuration | 149
N300 Wireless ADSL2+ Modem Router DGN2200
The LAN addresses used in this example are as follows:
Table 12.
Device LAN IP Address LAN Subnet Mask
DGN2200 10.5.6.1 255.255.255.0
FVL328 172.23.6.1 255.255.255.0
a. Enter toFVL328 for the connection name.
b. Enter fvl328.dyndns.org for the remote WAN's IP address.
c. Enter the following:
• IP Address: 172.23.9.1
• Subnet Mask: 255.255.255.0
5. Configure the FVL328 as in the gateway-to-gateway procedures for the VPN Wizard (see
Set Up a Gateway-to-Gateway VPN Configuration on page 108), being certain to use
appropriate network addresses for the environment.
a. Enter toDG834 for the connection name.
b. Enter dg834g.dyndns.org for the remote WAN's IP address.
c. Enter the following:
• IP Address: 10.5.6.1
• Subnet Mask: 255.255.255.0
6. Test the VPN tunnel by pinging the remote network from a PC attached to the DGN2200.
a. Open the command prompt (Start -> Run -> cmd)
b. Type ping 172.23.9.1
If the pings fail the first time, try the pings a second time.
Configuration Summary (Telecommuter Example)
The configuration in this section follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather the necessary information before you begin configuration.