Owner's Manual

114 | Chapter 8. Virtual Private Networking
N300 Wireless ADSL2+ Modem Router DGN2200
This causes a continuous ping to be sent to the first DGN2200. Within 2 minutes, the
ping response should change from timed out to reply.
Note: You can use Ctrl-C to stop the pinging.
Once the connection is established, you can open a browser on the PC and enter the
LAN IP address of the remote DGN2200. After a short wait, you should see the login
screen of the modem router (unless another PC already has the DGN2200 management
interface open).
• Gateway-to-gateway configuration. Test the VPN tunnel by pinging the remote network
from a PC attached to Gateway A (the modem router).
a. Open a command prompt (for example, Start > Run > cmd).
b. Type ping 192.168.3.1.
Note: The pings might fail the first time. If they do, then try the pings a
second time.
Start Using a VPN Tunnel to Activate It
To use a VPN tunnel, use a Web browser to go to a URL whose IP address or range is
covered by the policy for that VPN tunnel.