Quick Reference Guide

ADSL2+ Modem Wireless Router DG834G Reference Manual
6-6 Virtual Private Networking
v2.0, September 2007
• “Step 1: Configuring the Client-to-Gateway VPN Tunnel on the DG834G v4” on page 6-6
describes how to use the VPN Wizard to configure the VPN tunnel between the remote PC and
network gateway.
• “Step 2: Configuring the NETGEAR ProSafe VPN Client on the Remote PC” on page 6-9
shows how to configure the NETGEAR ProSafe VPN Client endpoint.
Step 1: Configuring the Client-to-Gateway VPN Tunnel on the
DG834G v4
The worksheet in Table 6-3 identifies the parameters used in the following procedure. A blank
worksheet is at “Planning a VPN”.
Follow this procedure to configure a client-to-gateway VPN tunnel using the VPN Wizard.
Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in Table 6-2 on page 6-4. If you have special requirements
not covered by these VPNC-recommended parameters, refer to “Setting Up VPN
Tunnels in Special Circumstances” on page 6-32 to set up the VPN tunnel.
Table 6-3. VPN Tunnel Configuration Worksheet
Connection Name: RoadWarrior
Pre-Shared Key: 12345678
Secure Association -- Main Mode or Manual Keys: Main
Perfect Forward Secrecy -- Enabled or Disabled: Disabled
Encryption Protocol -- DES or 3DES: 3DES
Authentication Protocol -- MD5 or SHA-1: SHA-1
Diffie-Hellman (DH) Group -- Group 1 or Group 2: Group 2
Key Life in seconds: 28800
(8 hours)
IKE Life Time in seconds: 3600 (1 hour)
VPN Endpoint Local IPSec ID LAN IP Address Subnet Mask
FQDN or Gateway IP
(WAN IP Address)
Client toDG834 — — Dynamic
DG834G v4 toClient 192.168.3.1 255.255.255.0 22.23.24.25