Quick Reference Guide
Table Of Contents
- Reference Manual for the ADSL Modem Wireless Router DG834G
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Wireless Configuration
- Chapter 4 Protecting Your Network
- Chapter 5 Managing Your Network
- Chapter 6 Advanced Configuration
- Chapter 7 Virtual Private Networking
- Chapter 8 Troubleshooting
- Appendix A Technical Specifications
- Appendix B NETGEAR VPN Configuration
- Appendix C Related Documents
Reference Manual for the ADSL Modem Wireless Router DG834G
Virtual Private Networking 7-29
v1.0, January 2006
VPN Tunnel Control
Activating a VPN Tunnel
There are three ways to activate a VPN tunnel:
• Use the VPN Status page.
• Activate the VPN tunnel by pinging the remote endpoint.
• Start using the VPN tunnel.
Using the VPN Status Page to Activate a VPN Tunnel
To use the VPN Status screen to activate a VPN tunnel, perform the following steps:
1. Log in to the Modem Router.
2. Open the DG834G v3 management interface and click on VPN Status to get the VPN Status/
Log screen (Figure 7-29).
Note: Refer to “Using Auto Policy to Configure VPN Tunnels” on page 7-38 to enable
the IKE keepalive capability on an existing VPN tunnel.
Figure 7-29