Quick Reference Guide

Reference Manual for the Model Wireless ADSL Firewall Router DG834G
F-12 NETGEAR VPN Configuration
202-10006-05, June 2005
5. Configure the DG834G as in the Gateway-to-Gateway procedures using the VPN Wizard (see
“How to Set Up a Gateway-to-Gateway VPN Configuration“ on page 8-20), being certain to
use appropriate network addresses for the environment.
The LAN Addresses used in this example are as follows.
• DG834G
LAN IP = 10.5.6.1
LAN Subnet Mask = 255.255.255.0
•FVL328
LAN IP = 172.23.9.1
LAN Subnet Mask = 255.255.255.0
a. In Step 1, enter toFVL328 for the Connection Name.
b. In Step 2, enter fvl328.dyndns.org for the remote WAN's IP address.
c. In Step 3, enter the following:
• IP Address = 172.23.9.1
• Subnet Mask = 255.255.255.0
6. Configure the FVL328 as in the Gateway-to-Gateway procedures for the VPN Wizard (see
“How to Set Up a Gateway-to-Gateway VPN Configuration“ on page 8-20), being certain to
use appropriate network addresses for the environment.
a. In Step 1, enter toDG834 for the Connection Name.
b. In Step 2, enter dg834g.dyndns.org for the remote WAN's IP address.
c. In Step 3, enter the following:
• IP Address = 10.5.6.1
• Subnet Mask = 255.255.255.0
7. Test the VPN tunnel by pinging the remote network from a PC attached to the DG834G.
a. Open the command prompt (Start -> Run -> cmd)
b. ping 172.23.9.1