User Manual

NETGEAR M4500 Series Switches CLI Command Reference Manual 842
To reset the maximum response time interval for the specified interface to the default value, use the no form of
this command.
Format ip igmp query-max-response-time <0-3174>
no ip igmp query-max-response-time
Default 10 seconds
Mode Interface Config
7.1.2.8. ip igmp robustness
This command configures the robustness that allows tuning of the interface. The robustness is the tuning for the
expected packet loss on a subnet. If a subnet is expected to have a lot of loss, the Robustness variable may be
increased for the interface.
To reset the robustness value to the default value, use the no form of this command.
Format ip igmp robustness <1-255>
no ip igmp robustness
Default 2
Mode Interface Config
7.1.2.9. ip igmp startup-query-count
This command sets the number of Queries sent out on startup, separated by the Startup Query Interval on the
interface.
To reset the number of Queries sent out on startup to the default value, use the no form of this command.
Format ip igmp startup-query-count <1-20>
Fields
Definition
<1-3174>
The range for query-max-response-time is from 0 to 3174 seconds.
IGMP version 3
range 1-3174, version 2: range 1-25, version 1: range 1-25
Fields
Definition
<1-255>
The range for robustness is from 1 to 255.